Valera Trimmy nose and ear hair trimmer

WARNINGS

• Do not push the unit hard into the nose or ears. Only the metal tip of the head should be inserted delicately into the nose and ear cavities.
• Do not use your unit if it is not working properly, or if there is any damage to the head or the set of blades: doing so may result in injury to the skin, nose or ears. Do not attempt to repair the electrical unit yourself; instead, you should contact an authorized technician.
• This unit is only designed to trim nose and ear hair. Any other type of use should be considered improper, and therefore dangerous. The manufacturer cannot be held responsible for any damage resulting from improper or incorrect usage.
• Warn children of the dangers of electrical equipment and inform them of the relevant safety standards. Never leave electrical equipment within reach of children.
• Children should be supervised to ensure that they do not play with the appliance.
• The elements used to pack the unit (plastic bags, cardboard box, etc.) must be kept out of reach of children as they are a potential danger to them.

INSERTING / REPLACING THE BATTERY

Remove the battery cover by moving it in the direction of the white arrow. Remove the exhausted battery, if there is one. Fit a new “AAA” battery in the unit. Close the battery cover again. In compliance with environmental protection regulations, please remember not to discard old batteries in the normal household waste, but always dispose of them at a specific collection point.

OPERATING INSTRUCTIONS

Turn the unit on using the ON/OFF button.

Using the Nose and Ear Head

Insert the metal tip of the head into the nose or ear gently and with great care, to cut unwanted hair.

CLEANING AND MAINTENANCE

Important

Always make sure that the unit is turned off before cleaning the blades. Never immerse the entire unit in water. The only parts that can be cleaned with water are the set of blades and the head.

To clean hair clippings from the unit, remove the head by turning it anticlockwise and take out the set of blades. Clean the two parts using the brush provided or rinse them. Make sure that both the head and the set of blades are completely dry before reassembling them. Use a soft cloth to dry them. Use the small brush provided to clean the beard and sideburn head. The body of the unit can also be cleaned using a soft cloth. Never use abrasive detergents or solvents.